Rosemount 848T Especificações descarregar pdf (Página 8)

December 2014

Quick Start Guide

2. Angle adapter and slide spade lugs into terminals 2 and 3 on the left side, as

shown in the figure below. Ensure that the positive and negative polarity

indicators match on the adapter and the terminal block.

3. Lower right side of adapter into terminals 2 and 3 on the right side and center

the adapter.

4. Tighten all terminal screws to lock divider in place.

Step 2: Verify operation

Operation can be verified using one of three methods: Field Communicator, the

Smart Wireless Gateway’s integrated web interface, or via AMS

Wireless

Configurator.

Field Communicator

For HART communication, an 848T Wireless DD is required. For connecting with a

Field Communicator, refer to Figure 3 on page 4.

Smart Wireless Gateway

In the Gateway’s integrated web interface, navigate to the Explorer page. This

page shows whether the device has joined the network and if it is communicating

properly.

Note

It may take several minutes for the device to join the network.

Note

If the device joins the network and immediately has an alarm present, it is likely due to sensor

configuration. Check the sensor wiring (see “Rosemount 848T Terminal Diagram” on page 10) and

the sensor configuration (see “848T Fast Key Sequence for Field Communicator” on page 10).

Function Key sequence Menu items

Communications 3,3

Join Status, Communications Status, Join

Mode, Number of Advertisements Heard,

Number of Available Neighbors, Number

of Join Attempts

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Sem comentários

Rosemount 848T Especificações Página 8